基于SPR原理的D型镀银光纤湿度传感器

郭翔宇; 张祖兴

doi:10.13756/j.gtxyj.2024.230132

您当前的位置：

首页 >

文章列表页 >

基于SPR原理的D型镀银光纤湿度传感器

光电器件研究与应用 | 更新时间：2024-12-05

- 基于SPR原理的D型镀银光纤湿度传感器
- Humidity Sensor of D-shaped Silver-coated Optical Fiber based on SPR Effect
- 光通信研究 2024年第6期页码：23013201-23013207
- 作者机构：
  
  南京邮电大学　电子与光学工程学院、柔性电子（未来技术）学院，南京　210046
- 作者简介：
  
  郭翔宇（1997-），男，江苏高邮人。硕士，主要研究方向为光纤传感。
  张祖兴，教授。E-mail：zxzhang@njupt.edu.cn
- 基金信息：
- DOI：10.13756/j.gtxyj.2024.230132
  中图分类号： TN253
- 纸质出版日期：2024-12-10，
  
  收稿日期：2023-09-31，
  
  修回日期：2023-10-30，
- 稿件说明：
移动端阅览
郭翔宇，张祖兴. 基于SPR原理的D型镀银光纤湿度传感器[J]. 光通信研究，2024(6):230132.

Guo X Y, Zhang Z X. Humidity Sensor of D shaped Silver coated Optical Fiber based on SPR Effect [J]. Study on Optical Communications, 2024(6):230132.
郭翔宇，张祖兴. 基于SPR原理的D型镀银光纤湿度传感器[J]. 光通信研究，2024(6):230132. DOI： 10.13756/j.gtxyj.2024.230132.

Guo X Y, Zhang Z X. Humidity Sensor of D shaped Silver coated Optical Fiber based on SPR Effect [J]. Study on Optical Communications, 2024(6):230132. DOI： 10.13756/j.gtxyj.2024.230132.

摘要

【目的】

为了获得更高灵敏度的光纤湿度传感器，文章提出了一种基于SPR原理的D型镀银（Ag）湿度传感器。

【方法】

文章将氧化石墨烯（GO）涂敷在D型镀Ag光纤表面，由于GO具有吸水特性且吸水后有效折射率（RI）会发生变化，当满足一定条件时会激发表面等离子体共振（SPR）效应，因此可以用作湿度传感。为了使传感器获得最大SPR灵敏度，首先通过COMSOL Multiphysics软件对D型镀Ag光纤的结构进行建模，采用有限元分析法探究抛磨深度和Ag膜厚度对传感特性的影响，然后通过实验验证结构参数的有效性和合理性，最后在D型镀Ag光纤表面再涂覆一层GO薄膜探究其湿度检测的性能。

【结果】

仿真结果表明，最佳传感器结构为抛磨深度为58.4 μm、Ag膜厚度为50 nm，其在环境RI范围为1.34～1.40时获得的最大波长灵敏度为5 500 nm/RIU。在该参数的基础上通过实验验证RI传感特性，传感器获得了最大为3 668 nm/RIU的波长灵敏度，基准值R平方值为0.98，具有良好的线性。再在表面涂敷GO薄膜后，相对湿度由30%变化至90%，获得了0.545 nm/%RH的湿度灵敏度，相对湿度升高和降低两种情况下的线性R平方值分别为0.961 1和0.971 1，重合度良好。

【结论】

仿真结果和实际实验的共振峰变化区间相同，说明了该传感器的有效性和合理性，GO隔绝了Ag膜与空气的接触，防止了氧化，将其吸水特性和金属薄膜SPR特性结合所获得的光纤湿度传感器显示出了较高的灵敏度，为高灵敏度的湿度传感器设计提供了一种思路。

Abstract

【Objective】

In order to obtain a higher sensitivity fiber optic humidity sensor

this paper proposes a humidity sensor of D-shaped silver (Ag)-coated optical fiber based on Surface Plasmon Resonance (SPR) effect.

【Methods】

Graphene Oxide (GO) is coated on the surface of D-shaped Ag-coated optical fiber. Since GO has water absorption characteristics and the effective Refractive Index (RI) will change after absorbing water

SPR will be excited when certain conditions are met. Therefore

it can be used as a humidity sensor. In order to obtain the maximum SPR sensitivity of the sensor

the structure of D-type Ag-coated optical fiber is firstly modeled by COMSOL Multiphysics software

and the influence of polishing depth and Ag film thickness on the sensing characteristics is explored by finite element analysis. Then the structure is verified by experiments Validity and rationality of parameters. Finally

a layer of GO film is coated on the surface of the D-shaped Ag-coated optical fiber to explore its performance of humidity detection.

【Results】

The simulation results show that the optimal sensor structure is the polishing depth of 58.4 μm

the thickness of the Ag film is 50 nm

and the maximum wavelength sensitivity of 5 500 nm/RIU is obtained between the ambient RI of 1.34 and 1.40. On the basis of this parameter

the RI sensing characteristics are verified through experiments. The sensor has a maximum wavelength sensitivity of 3 668 nm/RIU

and the R square value is 0.98

which has good linearity. After coating the GO film on the surface

the humidity sensitivity of 0.545 nm/%RH is obtained when the relative humidity changes from 30% to 90%

and the linear R-squared values under the two conditions of increasing and decreasing relative humidity are 0.961 1 and 0.971 1

respectively.

【Conclusion】

The simulation results and the actual experiment have the same resonance peak change range

which shows the effectiveness and rationality of the sensor.GO isolates the Ag film from contact with air

preventing oxidation. The optical fiber humidity sensor obtained by combining its water-absorbing properties with the SPR properties of the metal film demonstrates high sensitivity

providing a novel approach for the development of highly sensitive humidity sensors.

关键词

D型光纤表面等离子体共振氧化石墨烯湿度传感器

Keywords

D-shaped optical fiberSPRGOhumidity sensor

references

王庆波, 窦超. 光纤传感器的发展综述[J]. 科技视界, 2016(27):471.

Wang Q B, Dou C. Review on the Development of Optical Fiber Sensors[J]. Science & Technology Vision, 2016(27):471.

Xi X, Xu J, Li S, et al. An Au Nanofilm-Graphene/D-type Fiber Surface Plasmon Resonance Sensor for Highly Sensitive Specificity Bioanalysis[J]. Sensors, 2020, 20(4):991.

Wang Q, Jing J Y, Wang X Z, et al. A D-shaped Fiber Long-range Surface Plasmon Resonance Sensor with High Q-factor and Temperature Self-compensation[J]. IEEE Transactions on Instrumentation and Measurement, 2020, 69(5):2218-2224.

Tshabalala Z P, Shingange K, Dhonge B P, et al. Fabrication of Ultra-high Sensitive and Selective CH4 Room Temperature Gas Sensing of TiO2 Nanorods: Detailed Study on the Annealing Temperature[J]. Sensors and Actuators B: Chemical, 2017, 238:402-419.

Kamble V B, Umarji A M. Correlating Defect Induced Ferromagnetism and Gas Sensing Properties of Undoped Tin Oxide Sensors[J]. Applied Physics Letters, 2014, 104(25):1-12.

Oliveira L C, Moreira C S, Neff H, et al. Optical Properties and Instrumental Performance of Thin Noble Metal (Cu, Au, Ag) Films Near the Surface Plasmon Resonance[J]. Procedia Engineering, 2016, 168:834-837.

杨松岩, 何巍, 张钰民, 等. 镀金表面光子晶体光纤温度传感特性仿真分析[J]. 光通信研究, 2024(4):230008.

Yang S Y, He W, Zhang Y M, et al. Simulation Analysis of Temperature Sensing Characteristics of Photonic Crystal Fiber with Gold Plated Surface[J]. Study on Optical Communications, 2024(4):230008.

Gupta B D, Sharma A K. Sensitivity Evaluation of a Multi-layered Surface Plasmon Resonance-based Fiber Optic Sensor: a Theoretical Study[J]. Sensors and Actuators B: Chemical, 2005, 107(1):40-46.

Zakaria R, Lin W K, Lim C C. Plasmonic Enhancement of Gold Nanoparticles in Poly(3-hexylthiophene) Organic Phototransistor[J]. Applied Physics Express, 2012, 5(8):082002.

Mezher M H, Chong W Y, Zakaria R. Nonlinear Optical Response of Platinum Nanostructures and Application for Water Detection in Transformer Oil[J]. RSC Advances, 2016, 6(106):104624-104631.

Fu H, Zhang S, Chen H, et al. Graphene Enhances the Sensitivity of Fiber-optic Surface Plasmon Resonance Biosensor[J]. IEEE Sensors Journal, 2015, 15(10):5478-5482.

Jing J, Liu K, Jiang J, et al. Performance Improvement Approaches for Optical Fiber SPR Sensors and Their Sensing Applications[J]. Photonics Research, 2021, 10(1):01000126.

Zhang X, Zhu X S, Shi Y W. Improving the Performance of Hollow Fiber Surface Plasssmon Resonance Sensor with one Dimensional Photonic Crystal Structure[J]. Optics Express, 2018, 26(1):130-140.

Li J X, Tong Z R, Jing L, et al. Fiber Temperature and Humidity Sensor based on Photonic Crystal Fiber Coated with Graphene Oxide[J]. Optics Communications, 2020, 467:125707.

Kanmani R, Zainuddin N A M, Rusdi M F M, et al. Effects of TiO2 on the Performance of Silver Coated on Side-polished Optical Fiber for Alcohol Sensing Applications[J]. Optical Fiber Technology, 2019, 50:183-187.

Lin Y C. Characteristics of Optical Fiber Refractive Index Sensor based on Surface Plasmon Resonance[J]. Microwave and Optical Technology Letters, 2013, 55(3):574-576.

Niu L Y, Wang Q, Jing J Y, et al. Sensitivity Enhanced D-type Large-core Fiber SPR Sensor based on Gold Nanoparticle/Au Film Co-modification[J]. Optics Communications, 2019, 450:287-295.

Wang Y, Shen C, Lou W, et al. Fiber Optic Relative Humidity Sensor based on the Tilted Fiber Bragg Grating Coated with Graphene Oxide[J]. Applied Physics Letters, 2016, 109(3):031107.

Qiao S. Humidity Sensor based on Fiber Grating Coated with Graphene Oxide[J]. Journal of Physics: Conference Series, 2019, 1213(4):042076.

Fan X, Wang Q, Zhou M, et al. Humidity Sensor based on a Graphene Oxide-coated Few-mode Fiber Mach-Zehnder Interferometer[J]. Optics Express, 2020, 28(17):24682-24692.

Huang Y, Zhu W, Li Z, et al. High-performance Fibre-optic Humidity Sensor based on a Side-polished Fibre Wavelength Selectively Coupled with Graphene Oxide Film[J]. Sensors and Actuators B: Chemical, 2018, 255:57-69.

Yang H, Liu J, Liu B, et al. Investigation of Relative Humidity Sensing Using Tapered No-core Fiber Coated with Graphene Oxide Film[J]. IEEE Access, 2020, 8:220755-220761.

浏览量

下载量

CSCD

CNKI被引量

文章被引用时，请邮件提醒。

提交

工具集

关联资源

镀金表面光子晶体光纤温度传感特性仿真分析

基于SPR效应的液晶填充PCF电压传感